Accelerator GT V6.0 bêta

Here are the STL files for the v6.0 accelerator pedal as requested.

I indicate that it’s in beta and I didn’t print them, and probably wouldn’t, mainly due to lack of time.

It looks exactly like the clutch pedal, without the modifications specific to the latter (cable clamp screw, cable stop, cable guide). Everything else is the same so I think it should be good. The shopping list is the same as for the clutch pedal (link here) except for an M5x35 screw (for cable clamping).

The 3D files are available on thingiverse. Please give us feedback in comments if there is any problem or if everything is good.

I've been passionate about cars since I was a kid! I learned the multiple variations of the Skyline R34 through the Gran Tursimo series, until I discovered GTR2 at the wheel of a keyboard. A few years later, I plunged back into Sim Racing with a G27 which made me enter the DIY world. Always looking for an immersion out of reach in reality, I develop projects that I take care to make accessible to any 3D printer owner!
Posts created 124

Leave a Reply

Your email address will not be published.

Related Posts

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top